How to get Audio Hardware Setup show up always

All about Steinberg's Advanced Integration DSP Studio MR816 CSX and MR816 X.
Post Reply
Senior Member
Posts: 1196
Joined: Mon May 16, 2016 3:15 am

How to get Audio Hardware Setup show up always

Post by chikitin »

I hope you find this helpful.

1. Go to Yamaha FW driver and set it ADAT. Close and reopen it to make sure it is really set!
2. With Cubase open: go to Studio > Studio Setup and set ASIO driver to "No Driver".
3. Turn off both computer and MR.
4. Turn on MR first, once booted, boot the computer.
5. Wait till MR shows as an audio device on your computer.
6. open Cubase and add a new project.

Now, the Audio Hardware Setup should show up.

Maybe not important: in step 1: I have a sample rate to 44.1kHz and when I create a new project (step 6) I am choosing your sample rate. Maybe you want to start with your desire sample rate from the beginning.
MacBook Pro & iMac, 16GB RAM SSD 1 TB, Cubase Pro the latest w/ two external 32" Monitors
Surround configuration with subwoofer.
Dorico 3.5, Finale, VST Connect Pro, NI Komplete 5, EWQLSO, HSO, GA 5
Synths: Yamaha PSR-A3000, Roland Fantom XR
Interface: Steinberg MR-816CSX, UR 22 mkII
Effects: Rocktron DSP, Lexicon MPX 550
Controller: Steinberg CC121, Yamaha KX25,49,88, Korg Nano Kontrol, Boss RC 300, Yamaha MFC 10, CMC-PD

Post Reply

Return to “Steinberg MR816”

Who is online

Users browsing this forum: No registered users and 1 guest