Page 1 of 1

One- and two-bar repeat symbols

Posted: Wed Aug 16, 2017 5:43 pm
by MaxRBb
Hello,

I am looking for one- and two-bar repeat symbols, cannot find them. Are they hidden somewhere or can I copy and
paste them from somewhere?

Thanks Rolf

Re: One- and two-bar repeat symbols

Posted: Wed Aug 16, 2017 6:51 pm
by MarcLarcher
They are not implemented yet…

Re: One- and two-bar repeat symbols

Posted: Wed Aug 16, 2017 9:17 pm
by LSalgueiro
They're not in place yet, as Marc says, but you can copy and paste them as Text from the SMUFL documentation: https://w3c.github.io/smufl/gitbook/tab ... peats.html

It'll take some faking to properly pull off, though.

Re: One- and two-bar repeat symbols

Posted: Wed Aug 16, 2017 9:43 pm
by MaxRBb
Thanks:) Good enough for now;)

Re: One- and two-bar repeat symbols

Posted: Wed Oct 11, 2017 10:53 pm
by reednil
Is it possible to remove the rest that still is in the bar...?

Re: One- and two-bar repeat symbols

Posted: Wed Oct 11, 2017 11:41 pm
by MarcLarcher
You can remove rests with the "Remove Rests" command, in Edit menu, when in Write mode. However, that might change the bar length, so you might probably better change the rest opacity (in the Properties panel, color, alpha channel on PC or opacity on mac). You then make sure you print or export graphics with color "on", otherwise you will lose that opacity information.
Hope it helps…

Re: One- and two-bar repeat symbols

Posted: Fri Oct 13, 2017 11:04 pm
by reednil
Thanks for great support Marc! // Another Marc