Page 1 of 1
Nuendo 10 Dolby surround sound setup
Posted: Wed May 22, 2019 7:30 pm
Hey hi ppl...I was looking up for a new DAW for my studio ...currently I am using behringer x32 with cubase .....now I want to work on audio video production with nuendo 10 Dolby surround......can I use Behringer X32 as my audio interface and 5.1/7.1 Dolby surround sound mixer???
Any suggestions would be appreciated!
Re: Nuendo 10 Dolby surround sound setup
Posted: Thu May 23, 2019 1:54 pm
Do you really mean that you are going to encode to Dolby specifically, or are you just looking to do 5.1 / 7.1 surround in general? Those are two different things.
Nuendo has built-in surround panners and you can use those when mixing. All you have to do is set up the correct main output channel size and route your signals accordingly. All you need on the hardware side is enough outputs.
If you need bass management and control over delaying channels/speakers etc that can be done in the Control Room section with the bass management plugin.
Perhaps I'm not fully understanding your question...